15 PNP Transistors
Learning Objective
Theory Overview
On a practical level, PNP transistors may be thought of as a mirror image of their NPN counterparts. That is, all of the device’s voltage polarities and current directions will be opposite of those found with NPNs. In fact, a simple way to turn an NPN circuit into an equivalent PNP circuit is to swap out the transistor and then flip the polarity of the power supply (or supplies, as the case may be). The resulting circuit will produce essentially the same voltages and currents as the original but with reversed polarities. By no means are negative power supplies a requirement to use PNPs, though. Commonly, the circuit is “flipped top to bottom” and implemented with a positive supply. In this case the emitter will be found toward the top and the collector toward the bottom. In some instances this orientation may also reverse the operational logic of the circuit. For example, the “flipped” PNP LED driver becomes an inverting driver. That is, a logic low will light the LED instead of a logic high.
Equipment
| (1) Adjustable DC Power Supply | model: | srn: |
| (1) DMM | model: | srn: |
| (3) Small signal PNP transistors (2N3906) | ||
| (1) LED | ||
| (1) 220 Ω resistor ¼ watt | actual: | |
| (1) 3.3 k Ω resistor ¼ watt | actual: | |
| (1) 4.7 k Ω resistor ¼ watt | actual: | |
| (1) 5.6 k Ω resistor ¼ watt | actual: | |
| (1) 10 k Ω resistor ¼ watt | actual: |
Link
Download the datasheet:
Schematics
Procedure
PNP Voltage Divider
- Consider the circuit of Figure 1 using Vee = 10 volts, R1 = 10 kΩ, R2 = 3.3 kΩ, Re = 4.7 kΩ and Rc = 5.6 kΩ. Using the approximation of a lightly loaded “stiff” voltage divider, determine the theoretical base, emitter and collector voltages, and record them in Table 1 (Theory).
- Build the circuit of Figure 1 using Vee = 10 volts, R1 = 10 kΩ, R2 = 3.3 kΩ, Re = 4.7 kΩ and Rc= 5.6 kΩ. Measure the base, emitter and collector voltages and record them in the first row of Table 1 (Experimental).
- Swap the transistor with the second transistor and repeat steps 1 and 2 using the second row of the table.
- Swap the transistor with the third transistor and repeat steps 1 and 2 using the third row of the table.
Troubleshooting
- Consider each of the individual faults listed in Table 2 and estimate the resulting base, emitter and collector voltages. Introduce each of the individual faults in turn and measure and record the transistor voltages in Table 2.
PNP LED Driver
- Consider the PNP saturating switch of Figure 2 using Vee = Vbb = 5 volts, Rb = 4.7 kΩ and Rc = 220 Ω. Calculate the base and collector currents and record them in the first row of Table 3 (Theory). As the circuit is in saturation, the theoretical VCE is close to zero and may be found on the transistor data sheet via the VCE/IC saturation graph. Record this value in the first row of Table 3 as well.
- Build the saturating switch of Figure 2 using Vee = Vbb = 5 volts, Rb = 4.7 kΩ and Rc = 220 Ω. Measure and record the b