Buy or rent a texture hopper and air compressor.. Lay down drop cloths or plastic sheeting over your floor.. Use painter's tape to keep fixtures and switches dry.
Buy or rent a texture hopper and air compressor.
Lay down drop cloths or plastic sheeting over your floor.
Use painter's tape to keep fixtures and switches dry.
Attach the smallest nozzle to your hopper's spray gun.
Fill a large bucket halfway with joint compound.
Attach a mixing paddle to your drill.
Mix your joint compound with the paddle for 2-3 minutes to soften it up.
Add water to the bucket and continue mixing.
Stop mixing once your compound looks soupy and thin.
Hook your air hose up to the compressor and hopper.
Pour your mixed compound into the top of the hopper.
Turn the dial on your air compressor to 60-80 psi.
Hold your spray gun 18–24 in (46–61 cm) away from the wall.
Pull the trigger and spray back-and-forth in a 3 ft (0.91 m) section.
Move the spray gun down the wall while continuing to move it.
Repeat this process until you've covered your entire room.
Wait at least 48 hours for your texture to dry.
Comments (0)
No comments yet. Be the first to share your thoughts!